Crest Audio CV 20 - Manual (Page 6)

E
ight full-time stereo channels are provided standard on
all CV ™ 20 frame packages with the ability to add more
modules on custom frame packages. The stereo module is
divided into two types of channels.
The first four stereo input channels allow mic and line level
inputs. Each of these channels feature switches for 48-volt
phantom power, -25dB PAD and polarity. Included on each
mic/line stereo inputs are two separate gain controls for Left
and Right signals as well as Left/Right sum mono switches.
The second four stereo input channels allow patching of 2
separate stereo line signals. The first gain control is a stereo
gain pot that controls the ¼ inch inputs and the second
controls the RCA inputs for “set and forget” operation.
Switching between the 2 inputs is via the Line 2 switch. A
selectable HPF filter is also provided on all dual line inputs
that can be selected between 75 and 150 Hz. Left/Right
and Mono switching is also available as well as a pre-source
balance pot to send a discreet blend of the stereo signal to
the Auxes.
A four-band sweep able EQ is provided on all stereo inputs
for full EQ control of stereo signals. The stereo inputs also
provide 12 Auxiliary sends with the first 4 sends switch able
to the Matrices. This allows the Matrix to be expandable
from 11 x 4 to 19 x 4.
Bus/Mute and VCA assignments are just like the mono
inputs. Monitoring is via the Solo bus and separate signal
and peak displays for each channel.