CycleOps Comp 200E - Manual (Page 2)

1
CHAPTER 1:UNPACKING THE CYCLEOPS INDOOR CYCLE
Place the box upright and cut the plastic binding straps. Lift the top of the box to expose the Indoor Cycle (IC) and packaging.
Remove all parts from the box and foam inserts and ensure all the following parts are included:
Part Qty
Indoor Cycle Frame 1
Front V Foot 1
Back V Foot with wheels 1
Seat Post 1
Handlebars 1
Hardware 1
Hardware
Stabalizer bolts (8)
Washers (8)
Plastic cups(2)
Phillips-head screws (4)
5mm Allen wrench (1)
6mm Allen wrench (1)
15mm pedal wrench (1)
Phillips-head screwdriver (1)
2.5mm Allen wrench
CHAPTER 2: BIKE ASSEMBLY
Step 1: Attach Stabilizer Feet
1. Note the difference between the front and rear stabilizer feet. The larger foot with wheels goes in the rear of the IC.
2. Align the rear base of the frame with the rear stabilizer and secure it with four 6mm bolts with washers. NOTE: Tighten
the inner bolts fi rst, and then proceed to the outer bolts to ensure the foot is secured properly and evenly.
3. Repeat with the front stabilizer.
Front Stabilizer Feet Rear Stabilizer Feet
Tools Required
Vice Grips or small clamping tool
17mm Cone wrench
15mm box wrench
10mm box wrench
Pliers
3mm Allen wrench