CycleOps Comp 200E - Manual (Page 5)

4
IMPORTANT! How To Zero Torque
The torque must be zeroed to ensure that the console displays the most accurate power information. If the
instantaneous power is positive or negative, the torque needs to be zeroed. These operations must be done
with NO tension on the chain or with NO force being placed on the pedals. Also, the transmission icon must
be illuminated.
To zero torque, fi rst ensure the transmission icon is showing. Then press [DOWN ARROW] to move the cursor
to [WATTS]. Press [SELECT] to change to [INCH-LBS]. Then hold down [SELECT] again until “0” is shown (about
10 seconds). Press [SELECT] to return to [WATTS]. The torque value will now read zero.
You can secure the feet by tightening the
leveler locks.
Leveler Lock
Leveling the bike
Once the above assembly instructions have been followed, move the bike to where it will be used and level it properly. To level the
bike, adjust the leveling feet underneath the stabilizers until there is no rocking or movement of the bike.