Pro-Ject Audio Systems Amp Box DS - Manual (Page 2)

© Audio Trade GmbH · Pro-Ject Amp Box DS · Revision 2013.1.15
2
Dear music lover,
thank you for purchasing a PRO-JECT AUDIO amplifier.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
! Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Safety instructions
!
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply. The power cord is
used to disconnect the unit from the mains. Make sure that the power cord is easily accessible at all
times.
Never handle the device, the power cord/power supply while your hands are wet or damp.
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.
Never place any naked flame sources, such as lighted candles on or near the device. The product shall not
be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.
Connectors
Trigger
IN OUT
2x48V=
Pro-Ject Audio System
Vienna, Austria
Amp Box DS
!
Make all connections whilst the amplifier is disconnected from the power supply.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the
left channel black or white.
The red speaker terminals carry the positive signal (+), the black speaker terminals the negative
signal (–). Make sure the polarity of the connection is correct at each end of the cables.
Only connect one loudspeaker with an impedance not less than 4 ohms per channel.
Never use any other power supply than the one supplied with the unit.
Connection to the preamplifier
The RCA/cinch sockets marked Left / Right are for connecting the cables from your pre-amp or AV processor.
Connection to the speakers
The output terminals accept loudspeaker cables terminated with 4mm  Banana plugs, spades connectors
or naked wire.
Mains power connection
Connect the low voltage plug from the power supply to the 2x48V= socket of the amplifier before
connecting the power supply to the mains.