Pro-Ject Audio Systems Amp Box DS - Manual (Page 3)

© Audio Trade GmbH · Pro-Ject Amp Box DS · Revision 2013.1.15
3
Remote power on
The amplifier can be switched on & off via a special connection from the Pro-Ject Pre Box SE via the 2,5mm
socket marked Trigger IN.
A 45cm long power-on cable (polarity
+ ) is supplied for this purpose. Longer cables are available as
accessories. The remote power-on signal can be relayed to further units via the Trigger OUT socket.
To switch on from standby or to standby
The pushbutton on the front panel of the unit alternately turns the power on or returns it to standby mode. The
blue LED on the front panel shows that the unit is powered on.
Technical specifications Pro-Ject Amp Box DS
Power output: 2 x 100W/180W at 8 ohms/4 ohms (both channels driven)
Frequency response: 10Hz - 50kHz (+0dB, -3)
Channel separation: >40dB at 20kHz
Noise floor: >-90dB (A weighted)
THD: <0,1% at 90W
Gain: 26dB
Pre in:
1 pair RCA/phono sockets
Input sensitivity: 1,5V
Input impedance: 100kohms
Speaker connectors: 4mm  banana plugs, spades connectors or naked wire
Trigger: 12V DC switching voltage
Trigger in and out: 2-pole co-axial  2,5mm co-axial jack
Outboard power supply: ±48V/2,5A DC, suitable for your country's mains supply
Power consumption: 2,5A DC, <1W in standby
Dimensions W x H x D (D with sockets): 103 x 72 x 144 (163)mm
Weight:
1.400g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright
© 2012. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.