Pro-Ject Audio Systems Bluetooth Box S - Manual (Page 3)

© Pro-Ject Audio Systems · Pro-Ject Bluetooth Box S · Revision 2014.7.9
3
Main power switch
The push button on the left hand side of the front panel turns the unit on or back into standby. The blue LED
above the power button indicates the status of the unit:
Slow blinking: Powered on, waiting for devices (no Bluetooth device connected)
Fast blinking: Waiting for pairing confirmation - press power button to confirm pairing
Illuminated: Bluetooth device connected, ready to play
Output selector
Pressing the push button on the right side switches between the analogue output and digital outputs. LED
above selector is illuminated once digital output is selected.
Bluetooth pairing
Pairing with Android devices
Open Settings on Android device and tap on Bluetooth. Turn on Bluetooth and tap on Scan. Searched
devices will show up. Tap on "BT_Box_S" (Enter "0000" if requested) or confirm by pressing power button on
the left side of Bluetooth Box S as soon as the blue LED above power button is blinking. Once the device is
paired, it will show "Connected to media Audio". The device is now ready for playing music via Bluetooth
through Bluetooth Box S.
Pairing with Apple devices
Tap on Settings of Apple device, tap on Bluetooth, turn on Bluetooth, your device will automatically start
searching for available devices. Tap on "BT_Box_S" and confirm by pressing power button on Bluetooth Box
S, as soon as the blue LED on the left side is blinking.
Bluetooth Box S can store up to 8 Bluetooth devices. If the memory is full, further added devices
automatically replace the oldest stored. For a complete reset of the memory, turn off the unit > press
and hold power button for 5 seconds > release power button - All stored devices are now deleted.
The LED above output selector switch blinks 3 times, once aptX is active.
Troubleshooting
No music from my speakers:
- make sure an audio cable or an optical cable is correctly connected to Bluetooth Box S
- make sure you are within the range
- make sure the Bluetooth is enabled and the device is connected and volume level is properly set
!