Pro-Ject Audio Systems Bluetooth Box S - Manual (Page 4)

© Pro-Ject Audio Systems · Pro-Ject Bluetooth Box S · Revision 2014.7.9
4
Technical specifications Pro-Ject Bluetooth Box S
Effective working range: up to 10m (direct visibility)
Bluetooth Profile :
A2DP
Supported codecs: aptX, SBC
Frequency: 2402 ~ 2480 MHz
Sensitivity: - 84dBm
Maximum received signal at 0.1% BER: > = -10dBm
Maximum level of inter modulation interference: >= -30dBm
Spurious output level:
-156dBm/Hz
Audio Output Level (nominal): 2 Vrms
Frequency response: 20Hz - 20Khz
SNR (nominal, Audio RL): > 100 dB
THD (nominal, Audio RL): 0.02% (aptX)
Analog output: 1 pair RCA/cinch
Digital output: 1x coaxial (RCA/cinch), 1x optical (Toslink ® )
Dimensions W x H x D (D with sockets): 103 x 36 x 104 (109)mm
Weight: 576g
Outboard power supply: 9V/300mA
Power consumption: 9V/100mA max.
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only if the problem cannot be resolved there, the unit should be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
© 2014. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.