Pro-Ject Audio Systems DAC Box S FL - Manual (Page 3)

© Audio Trade GmbH · Pro-Ject DAC Box S FL · Revision 2013.1.15
3
To switch on from standby or to standby
The push button on the left hand side will toggle the DAC between its fully operational status and standby.
The blue LED above the stand-by push button shows that the unit is switched on.
Input selector
Pressing the grey button next to the two LEDs repeatedly selects the digital inputs in turns. The selected input will
be shown by the corresponding LED on the DAC Box S FL.
Technical specifications Pro-Ject DAC Box S FL
Line-level output: 1 pair RCA/phono sockets
Output voltage: 1,9Vrms
Digital outputs: 1 x coaxial (S/PDIF)
1 x optical (TOSlink ® )
D/A converter: Philips TDA 1543 16Bit/44,1kHz (4 converter in parallel mode)
without oversampling and digital filter
Supported audio format: PCM (LPCM). No support for multi channel formats like Dolby ® AC-3 or DTS ™
Sampling rates: 32kHz, 44,1kHz, 48kHz and 96kHz
Outboard power supply: 9V/300mA DC; suitable for your country's mains supply
Power consumption: 80mA DC, <1W in standby
Dimensions W x H x D (D with sockets): 103 x 36 x 104 (109)mm
Weight: 560g
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright
© 2011. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
TOSlink ® is a registered trademark of Toshiba corporation. Dolby ® is a registered trademarks of Dolby
Laboratories. DTS ™ is a registered trademark of DTS, Inc..