Technical specifications pro-ject power box rs amp, Service, Warranty – Pro-Ject Audio Systems Power Box RS Amp User Manual
Page 4: Copyright, trademarks
© Pro-Ject Audio Systems · Pro-Ject Power Box RS Amp · Revision 2014.4.15
4
Technical specifications Pro-Ject Power Box RS Amp
Input voltage:
AC 230V/50Hz IEC C15 connector (120V/60Hz US version)
Output voltage:
two outputs by 2 x 48V / 2.5A DC each
Filtration capacity:
40.000 µF
Output voltage ripple:
7mV peak to peak
Dimensions W x H x D:
201 x 72 x 195mm
Weight:
4,8kg
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer
for further advice. Only if the problem cannot be resolved there, the unit should be sent to the
responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these
instructions for use. Modification or changes to any part of the product by unauthorized persons
release the manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
©
2014. All rights reserved.
The information was correct at the time of going
to press. The manufacturer reserves the right to
make changes to the technical specification
without prior notice as deemed necessary to
uphold the ongoing process of technical
development.