Assembly – ProTemp PT-32-TTC User Manual

Page 8

Advertising
background image

NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR

WHILE CONNECTED TO A FUEL SOURCE

© 2014, Pinnacle Products International, Inc.

Propane Tank Top Heater User’s Manual

®

Assembly

47-TTC (Continued):

– To have all 3 burners face front, plane washer

should be to the right side of tank collar

bracket. (See Figure 6)

– To have far left burner face back, plane washer

should be to the left side of tank collar bracket.

(See Figure 6)

Figure 6

Connecting Heater to LP Cylinder:

Be sure to read and understand all of the Safety

Information in this manual before connecting

the heater to the LP cylinder. Installation must

conform to local codes and with the Standard

for the Storage and Handling of Liquefied

Petroleum Gasses and ANSI/NFPA 58.

Inspect the hose and regulator prior to each use

of the heater. If there is excessive abrasion or

wear, or if the hose is cut, replace it with the

proper assembly shown in the parts list prior to

using the heater.

Model 16-TTC:
1. Be sure that the control knob on the regulator

is in the “OFF” position.

2. Line up the threads on the fuel connector nut

with the threads on the LP cylinder valve. Turn

fuel connector nut COUNTERCLOCKWISE to

tighten. Fully tighten the nut, being careful not

to over tighten.

3. Slowly open the LP cylinder valve.

Models 32-TTC / 47-TTC:
1. Be sure that the control knob on the regulator

is in the “OFF” position.

2. Line up the slots in the tank collar bracket

with the tank collar ring and slide into place.

Be sure the mounting knob is to the outside,

and tighten.

3. Line up the threads on the fuel connector nut

with the threads on the LP cylinder valve. Turn

fuel connector nut COUNTERCLOCKWISE to

tighten. Fully tighten the nut, being careful not

to over tighten.

4. Slowly open the LP cylinder valve.

Check all connections for leaks using a

50/50 mixture of dish-soap and water. Any

bubbles appearing show a leak. Remove and

reconnect the Connector Nut to the valve.

DO NOT direct the heater

discharge towards any

propane cylinder located within 20 feet of

the heater.

WARNING

7

Advertising
This manual is related to the following products: