PulseTech PRO12 12-Station Battery Maintainer (746X912) - Manual (Page 2)

800-580-7554 2
If you sell, inventory or service lead-acid batteries, you want the battery you take off the shelf to be
as new as the day it was manufactured. However, batteries that sit idle continually discharge and are
subject to a naturally occurring build-up of lead sulfate deposits that reduce the battery’s ability to
accept, store and release energy.
The RediPulse Pro-12 ® tackles both problems. A continuous cycle of low amperage charging reverses
the normal discharge rate and optimized high frequency patented pulsing reduces the size and num-
ber of lead sulfate deposits. Your batteries will stay “factory fresh,” no matter how long they have
been sitting on the shelf.
Connect from 1 to 12 stored 12 V batteries from a single AC outlet. Completely safe – there’s no sparking
between the battery leads because current doesn’t flow into the cables until connected to the battery. An
audible alarm signals if the cables are reversed. LED lights indicate the status of individual batteries.
Important Safety Instructions
1. SAVE THESE INSTRUCTIONS - This manual contains important safety and operating instructions
for the battery maintenance charger model Pro-12.
2. Do not expose charger to rain or snow.
3. Use of an attachment not recommended or sold by the battery charger manufacturer may result
in a risk of fire, electric shock, injury to persons, or damage to product.
4. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when discon-
necting charger.
5. An extension cord should not be used unless absolutely necessary. Use of improper extension cord
could result in a risk of fire and electric shock. If extension cord must be used, make sure:
a) That pins on plug of extension cord are the same number, size, and shape as those of plug on
charger;
b) That extension cord is properly wired and in good electrical condition; and
c) That wire size is large enough for ac ampere rating of charger as specified in Table 1 (pg. 4).
6. Do not operate charger with damaged cord or plug – replace the cord or plug immediately.
7. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman.
8. Do not disassemble charger; take it to a qualified serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric shock or fire.
9. To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or
cleaning. Turning off controls will not reduce this risk.
10. WARNING – RISK OF EXPLOSIVE GASES.
a) WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EX-
PLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF UTMOST
IMPORTANCE THAT EACH TIME BEFORE USING YOUR CHARGER, YOU READ THIS MANUAL AND
FOLLOW THE INSTRUCTIONS EXACTLY.