PulseTech PRO12 12-Station Battery Maintainer (746X912) - Manual (Page 5)

www.pulsetech.net 5
Operating Instructions
PREPARATION FOR SERVICE & OPERATION
• Inspect the Pro-12 charger for visible damage which might have occurred during shipping and
delivery.
• Plug the AC adapter into an electrical outlet (110-volt or 220-volt depending on unit). NOTE: This
adapter is specially designed for this unit. DO NOT use any other adapter. If the adapter has to be
replaced at some point in time, contact PulseTech to order another one.
• Connect the separate positive and negative clamps to each battery (one single 12 V battery or two
6 V batteries connected in series to equal 12 volts — DO NOT use on12V batteries in series). For
single 12 V batteries: Attach the red positive (+) clamp to the positive (+)battery post and the black
negative (-) clamp to the negative (-) battery post. For 6 V batteries in series: Attach the positive
wire to the positive terminal on Battery 1 and the negative to the negative terminal on Battery 2. If
an audible alarm sounds, it indicates an improper connection.
• Turn the POWER switch to the ON position.
• The Pro-12 will initiate a self test during which each of the 12 battery LED indicators will come on
green, turn yellow and then red. Then the Pulse and Charge indicator LED will come on.
• Once the self test is complete, the unit will begin cycling through each of the batteries connected. A
RED LED indicates
the battery is dis-
charged;
YELLOW
indicates marginal;
and
GREEN indi-
cates the battery is
ready for issue.
NOTE: The Pro-Series is capable of restoring recoverable batteries (no damaged plates or
cells) to their maximum potential, but results will vary per battery. Also, the amount of time it takes to effec-
tively clean the battery plates will vary depending on age and/or condition of each battery.
Precautions
DO NOT USE THIS PRODUCT ON BATTERIES INSTALLED IN VEHICLES. Always remove battery from
vehicle prior to charging.
• Use each set of wires only on one single 12V battery or two 6V batteries connected in series to
equal 12 volts. DO NOT use on 12V batteries in series.
• Make sure the correct terminal attachments are connected to the correct terminals (i.e. red on
positive and black on negative).
Technology
What makes the ReNew-IT Pulse Technology utilized by PulseTech products so unique — and so
effective — is the distinct pulse waveform that defines it. This patented waveform has a strictly con-
trolled rise time, pulse width, frequency, and amplitude of current and voltage pulse. No other battery
maintenance systems in the world has this specific waveform which means no other system can
provide the same exceptional benefits as PulseTech battery charging and maintenance systems.