PulseTech QuadLink 4-Channel Battery Charge Distribution System (100X004) - Manual (Page 3)

User Guide
1
Do not operate without fi rst reading these important safety notices and use instructions.
Additionally, do not use this without fi rst reading important safety notices and use
instructions that come with your battery charger/maintainer and your battery.
NOTE: As part of good safety routine, this product is designed for use only with automatically controlled
charger maintainers and is optimized for use with the Xtreme Charge family of products. It is not
suggested for use with manual maintenance chargers that cannot be used without constant supervision.
1. Inspect all cable leads and connections to be sure that they are all in good working condi-
tion. Never use cable leads or clips that are worn, damaged or frayed in any way. Replace
worn or damaged leads prior to use. Do not alter or otherwise modify cables as this could
cause an unsafe condition possibly resulting in personal injury, explosion or fi re.
2. Connect the output of your battery charger/
maintainer to the input of the QuadLink.
Note: The charger must have the same industry
standard 2-prong connector to mate properly
with the QuadLink.
3. Connect the extension leads that come with the QuadLink to either the standard attached
battery eyelet connector on each vehicle battery and/or to the charging clip set that comes
with your charger. Be sure to fi rst connect the red battery clip to the positive (+) battery
terminal. Then connect the black battery clip
to the negative (-) battery terminal. Also, be
sure to double check that your attached eyelet
terminal cable sets are properly polarized.
Once you have connected the cable leads to
all batteries in use, you can begin the battery
maintenance process by plugging in your
charger to your AC power source.
4. What is happening:
A. Your battery charger is still in full control of the charging processes. Always refer to the
battery charger manufacturer’s instructions or the user interface on your charger to
determine what state of charge your battery is in.
B. The QuadLink is almost transparent to the battery. It does not add to the charging
capabilities of your charger, just to the number of batteries being maintained. Your
charger is still the “brain” in the system.