Cambex AIX PC2000 - Manual (Page 10)

FibreQuik - Fibre Channel Adapter User Guide
example, if errpt identifies a loose cable on device cda1, lsdev
will give an address similar to:
cda1 Available 00-02-01-3,0 Cambex SCSI...
Which indicates that the adapter is in location 00-02, and the
drive is at SCSI ID 3, LUN 0.
Checklist for driver and HBA installation
The following commands may be used to isolate problems
during installation of the fibre channel driver and card. Type
the command shown in bold and verify the output.
whoami
must be root
uname -a
must give 5 fields:
'AIX'
hostname where card is installed
1 or higher as minor rev of AIX
4 as version of AIX
serial number of host
lslpp -l PC1000.driver.obj
must give:
Fileset Path: /usr/lib/objrepos PC1000.driver.obj
Level 01.05.00.00 (or greater)
State Committed
Description Cambex Fibre Channel Adapter Driver
lsdev -Cc adapter
should print a line for each card:
scsi<x> <x> is a unique number for each SCSI card
Available <SS-SS> <S> is the location in the machine where
the card is installed
Check that the number of SCSI cards and their slots are correct
If
'Available'
then card and driver are installed.
If
'Defined'
or not listed then card was not found.
- 8 -