SOLIS Grinder Scala - Manual (Page 11)

11
SOLIS Coffee-grinder
Important instructions
Quantity Control
The SOLIS coffee grinder is preset to the
medium grinding postition.
Always keep the lid (1) of the bean container
tightly shut in order to enjoy the full taste
and aroma of your coffee beans. Never grind
more coffee than you actually need.
The SOLIS coffee grinder is equipped with a
time control (7). Use it to set the coffee
grinder to the desired grinding time and
quantity. The appliance switches off
automatically once the preset time has
elapsed. If you want to interrupt grinding
before the preset time has elapsed, simply
turn the rotary knob back to the left until the
appliance switches off.
The numbers alongside the control knob
denote the various quantities dispensed by
the proportioning system.
As a rough guide (only applicable when
using coarse grinding)
Quantity control number = number of cups
Example: setting "3" = 3 cups.
The quantity of ground coffee you need to
make your coffee depends on the type of
bean, the degree of grinding and your
personal taste.
Warning:
Stone safety cut-out feature
Cleaning the grinding gear
After each unit (10 cups), empty the coffee
container (6). This prevents the motor
overheating.
Given the huge quantities of coffee that are
packed every day, very small stones may
accidentally find their way into even the
finest coffee beans. The appliance is
equipped with a stone safety cut-out
("friction clutch") in order to prevent damage
to the grinding gear. A stone in the grinding
gear will cause a loud rattling noise. Switch
the appliance off immediately, remove plug
from wall outlet, open it as described in the
section entitled "Cleaning the grinding
gear" and remove the stone.
Disconnect the mains plug from the socket
outlet. Remove any remaining beans in the
bean container (fig. 6) and take the latter off
by twisting it in an anticlockwise direction as
far as the release area stop (fig. 7). Lift the
bean hopper from the housing (fig. 8). The
grinding ring can then be lifted out of the
machine.
A soft-bristle brush is ideal for cleaning the
grinding gear. Re-assemble the machine by
performing the above operation in reverse
order. Housing and transparent parts can be
cleaned easily using a damp cloth.