SOLIS Smart Heater - Manual (Page 11)

20 21
PRODUCT DESCRIPTION
1. ON/OFF power switch
2. air outlet grille
3. touch panel and LCD display
4. removable air filter
5. air inlet grille
6. feet rubber
7. power cord
OPERATING INSTRUCTIONS
Firstly connect the power cord with correct power supply (220-240V~).
Press the ON/OFF power switch (no. 1 in the picture) to “I” position.
The unit is in stand-by mode after two “didi” sound. Then press on/off (stand-by)
key to make the unit working and all functions available.
Press the power switch to “0” position to turn off the fan heater.
Please follow the instructions on next page to use the different functions of the fan heater.
ON/OFF (STAND-BY)
LIGHT
ON/OFF (STAND-BY) KEY
When you touch this Key, the operation symbol
(RED) appears and the unit begins operating at
low power level: the indication
“Low” appears
on display, below on the left, and the ambient
temperature appears too.
POWER LEVEL INDICATOR
(Low = 1300 W
High = 2000 W)
LED DISPLAY:
TEMPERATURE OR TIME
When both temperature
and time are set, the display
shows alternatively the
ambient temperature or the
resting time.
POWER LEVEL KEY
When you press this Key, the heating power pass
from low to high level (from 1300W to 2000W):
on display it appears the indication “High”. If you
continue to press this key the power level changes
from one to the other level.
TEMPERATURE KEY
When you press this Key, you can choose the
desired temperature, from 5 to 35° C. To set the
temperature you have to press this key, press + or
– key and then wait 5”, for setting confirmation.
The temperature then shown on the display
will be the ambient temperature.
+/- KEYS
When you press this Key, You can choose
the desired temperature, from 5 to 35° C, or
the time, from 1 to 12 hours (by 1h step).
TIMER (SWITCH OFF TIME)
To fix a time for the operation of the unit (from
0 to 12 hours, by 1h step), press this key and
then + or – key to fix the time and then wait 5”,
for setting confirmation.
N.B.
When the temperature set is reached, the unit goes in stand-by mode, the power level indica-
tion disappears and air circulation stops after 10”.
When the ambient temperature is 2° C below the set temperature, the units begins operating
again at the same power level previously set.
THIS FAN HEATER CAN BE PLACED ON THE FLOOR, ON A SHELF OR ON THE WALL: IN THE LAST
CASE YOU MUST TAKE THE SPECIAL HOLDER SUPPLIED WITH THE PRODUCT AND INSTALL IT
ON THE WALL, AS BY FOLLOWING INSTRUCTIONS and PICTURES.
Solis_Smart_Heater_Betriebsanleitung.indd 20-21 08.04.10 17:16