SONiVOX Vocalizer Pro - Manual (Page 17)

17
Module Parameters
Each module has several adjustable parameters to control Vocalizer Pro's underlying spectral
synthesis engine. Used in conjunction with the envelope controls mentioned in the Envelopes
section, these parameters offer you countless ways of shaping your audio.
•
Filter: This drop-down menu determines the type of
filter used in the envelope. Set its parameters by
adjusting the knobs below it: Freq (frequency), Q
(resonance), and Sat (saturation).
• Pitch: This slider determines the pitch of the
harmonics in relation to the incoming MIDI note(s).
The slider ranges from 0 to 96. This scale of value
is affected by the selected Oct (octave range) tab
above the slider, whose range is from -1 to +8 octaves. For example, if the +2oct tab is
selected, the Pitch slider's range represents the pitches across two octaves.
Note: If the -1oct tab is selected, then the Pitch slider represents two octaves,
beginning at one octave below the fundamental MIDI note entering the engine.
• Balance: This slider determines the amount of even
and odd harmonics emphasized in or extracted from
the incoming audio signal. The further to the right
the slider is set, the more even harmonics and even
harmonic intensity will occur. The further to the left, the more odd harmonics and harmonic
intensity will occur. The closer to the center the slider is, the dryer the sound will be.