Lfos, Routing – SONiVOX Vocalizer Pro User Manual
Page 18
18
•
Amp: Set the volume of each voice by adjusting the Vol slider. Change the
tuning by adjusting the Tune knob.
LFOs
Each processor has as many LFOs as it has envelopes.
Select which envelope you want to view or adjust by
clicking the desired tab under the Envelope Pane:
Filter, Pitch, Balance, or Amp (A2 and B2 only).
Select the LFO wave type by clicking the LFO (low-frequency oscillator) drop-down menu.
Adjust its rate and amount with the Rate and Amt (amount) knobs, respectively.
You can synchronize the LFO with the clock of your host software by turning the Sync switch
on. When Sync is on, the Rate knob becomes the Res (resolution) knob, which determines the
LFO's time division relative to your software's clock.
Routing
You can easily change the routing of Vocalizer Pro's four processors by clicking the space
between any two adjacent processors.
A blue arrow indicates the direction of the signal flow. There
is a setting for either direction.
A red "no connection" symbol indicates no signal flow
between the two processors.