Sound Anchors DL5 system - Manual (Page 10)

Page 10 of 28
Description of the DESKLINE ® DL5/DL6 system
Each DESKLINE ® DL5/DL6 lifting units is equipped with a motor and parallel/memory drive is ensured by
means of software in the CBD4/CBD5/CBD6 that also takes account of oblique load on the desk. Soft start
and stop are also part of this software, which ensures a soft start and stop when adjusting the desk.
Application of the DESKLINE ® DL5/DL6 system:
Irrespective of the load the duty cycle 10% ~ 6 min./ hour or max. 2 min. at continuous use stated in
the data sheets, must NOT be exceeded as this will result in a superheating of the motor, the brake and the
spindle nut. Exceeding the duty cycle will result in a dramatic reduction of the life of the system.
The DESKLINE ® DL5/DL6 system range contains the following products:
• 1 control box CBD4/CBD5/CBD6
• 1 single DL5/DL6 or 2, 3, or 4 parallel
• 1 exchangeable mains cable
• 1, 2, 3, or 4 motor cables
• 1 DP1U/DPF1M (if memory function is required) DP1C/WDPL/DPT/DPF1C (if memory function and display is
required) or 1 DPA/DPB/DP1K/DP1V/DPF1K (if only up/down is required.)