Sound Anchors DL5 system - Manual (Page 11)

Page 11 of 28
Mounting guidelines for the DESKLINE DL5/DL6 system
Table top
Absorbing
material
Height of the DL5/DL6 in the lowest position
Min. desk height
Floor level
Figure 2
Figure 1
Max. 10 mm
DL5/DL6
motor housing
The lifting units are normally mounted with the motor housings upwards and pointing towards each
other (see fi gure 2).
The steel motor housing is supplied with 6 pcs. of M6 threaded holes meant for mounting on the desk
frame.
It is recommended to use all 6 M6 threaded holes. As the tabletop amplifi es the sound we advise you
to place a vibration/shock-absorbing material between the tabletop and the table frame.
A suitable desk height in the lowest position can be obtained by mounting the lifting unit on a 6-8 mm
bottom plate by means of 4 pcs. of M6 countersinked screws. We recommend you to use screws of min.
quality 8.8. The thrust moment must not exceed 10 Nm in the bottom plate thread.
The motor housing is supplied with 6 pcs. of M6 threaded holes meant for mounting on the desk frame. We
advise you to fasten the desk frame by means of 6 pcs. of M6 screws of a good quality and a suitable length,
which must not go further into the motor housing than max.10 mm. The thrust moment must not exceed max.
7.5 Nm.