Trail Tech X2 KIT: HALOGEN YAMAHA 36T2C-70 - Manual (Page 2)

010-ELV-75
X2
Tech Support: 360-687-4530
[email protected] X2
FEATURES AND WIRING
CABLE GUIDE:
CABLE GUIDE:
To install, thread the cables
through the cable guide, then
screw the cable guide to X2 as
shown to the right.
Be sure the cables are routed properly.
The forks compress a lot during riding,
make sure the cables have enough room
to move up and down without causing damage.
MX bikes should use Enduro brake lines for optimum
X2 fitment. Example: CRF uses CRFX brake line, YZF
uses WRF line, etc.
ROCK GUARD:
DEBRIS SHIELD:
Protect X2 from rocks and flying debris. Installs with an
insertion tab and a screw. Intended for racing, the rock
guard is optional. X2 will operate with or without the rock
guard in place. If you run X2 without the rock guard,
avoid gravel roosts. The lamp glass is extremely difficult to
damage, and is optically very clear.
ROCK GUARD VENT:
SILICONE HUMIDITY PLUG:
The rock guard works with a silicone gasket on X2 to create
a water-resistant barrier inside. Occasionally, water may still
find its way in. If fogging or moisture buildup occurs, remove
the vent plug (shown below as a red dot.) Use a paper clip
to poke through the silicone vent plug to allow air inside the
light.
STUB CONNECTOR:
WIRE COLOR
YELLOW
RED
BLACK
CONTROLS
4” SC4 BULB
2” MR16 BULB
GROUND
FUNCTION
HIGH BEAM
LOW BEAM
GROUND
CONNECT TO POWER:
Use the included wire stub connector to connect X2 to
power. The white connector allows for quick disconnect
and removal of X2 from the motorcycle. An on/off switch
is recommended. A fuse (10-20 amp) will protect from any
power spikes.
This stub connector is included in all X2 kits.
Complete wire harness with on/off switch sold separately.
VENT
PLUG