Sony MDS-501 - Manual (Page 7)

Unpacking
Checking the supplied accessories
Take the recorder out of the box and check that the following
accessories are included:
• Remote conunanderRM-DlM (1)
• Sony SUM-3 (NS) batteries (2)
• Audio coimecting cords (2)
• Recordable MD: MDW-60 (1)
Notes on installation
• Place the unit with the front panel facing you in a location
with adequate air circulation to prevent the unit from
overheating.
• Do not place the unit:
— near heat sources such as radiators or air ducts.
— in places subject to direct sunlight, excessive dust,
mechanical vibration or shock.
— in an inclined position.
— on a rug or other soft surface that would block the
ventilation holes on the bottom of the unit.
Do not throw away the carton and the packing
material
They will come in handy when transporting the unit or
shipping it for servicing.
Checking the operating voltage
Operate the unit only on 120 V AC, 60 Hz.
Before operating the unit, be sure that the operating
voltage of your unit is identical with that of your local
power supply.
Installing batteries into the remote
commander
On battery life
• About half a year of normal operation can be expected
when using the Sony SUM-3 (NS) batteries.
• When the batteries run down, the remote commander will
cease to operate the unit. In this case, replace both batteries
with new ones.
On handling
• Keep the commander away from extremely hot or humid
places.
• Avoid dropping any foreign objects into the commander
casing, particularly when replacing the batteries.
• Avoid exposing the remote sensor to direct sunlight or
lighting apparatus. Such exposure can cause a
malfunction.
• To avoid damage caused by battery leakage and corrosion,
remove the batteries when the commander will not be
used for a long time.
Should the front cover come off
Re-attach it as follows:
a 1 =^ L J &
o • a •a
Front cover
1 With the front cover in horizontal position,
position the bottom hinges onto their respective
pins, then press until the hinges snap in.
2 Close the front cover.
1 Open the remote commander cover.
2 Insert two Sony SUM-3 (NS) batteries with
correct polarity.