Receiving broadcasts, Press dual mode tuning - or -f, For a lower frequency – Sony HCD-241 User Manual
Page 8: For a higher frequency, To stop automatic tuning, Indicators in the display, When an fm stereo program is noisy, To change the am tuning interval, Note
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Receiving Broadcasts
This section describes about the various convenient ways of tuning.
Before reception, be sure to connect the supplied AM and FM antenna.
Press DUAL MODE TUNING - or -f.
For a lower
frequency
For a higher
frequency
• Tuning in automatically
Keep pressing DUAL MODE TUNING - or + for
about 1 second.
When a station is received, the automatic tuning
stops.
To stop automatic tuning
Press DUAL MODE TUNING - or +.
• Tuning in manually
Press DUAL MODE TUNING - or + to select the
staion.
Repeat step 3 until the desired station is
received.
Indicators in the display
• "TUNED” appears when a station is tuned in.
• "STEREO" appears when an FM stereo program of
sufficient signal strength is received.
When an FM stereo program is noisy
If the stereo program is noisy, press the STEREO/MONO
button to change the mode over the MONO. This eliminates
the stereo effect, but the noise will be reduced.
To return to the stereo mode, press the STEREO/MONO
button again.
To change the AM tuning interval
The AM tuning interval is preset at the factory to 10 kHz to
match the frequency allocation system of your country. To
change the interval to 9 kHz, prtKeed as follows.
1 Press the POWER switch to turn on the unit.
2 Press TUNER.
3 Set the BAND selector to AM.
4
Press ther POWER switch to turn the unit off.
5 While pressing the DUAL MODE TUNING + button, press
the POWER switch to turn the unit on.
To reset the interval to 10 kHz, follow the same prwedure.
Note
When the interv'al is changed, all stored stations will be
erased from the memory. After changing the interval, be
sure to store the stations again.
8