Sony SPP-A900 - Manual (Page 37)

Turning on the transfer function
Press (TRANSFER),
The transfer function is turned on and the
TRANS indication appears in the display
window.
You will hear the destination number and
To turn off the transfer function
Press (TRANSFER).
The transfer function is turned off and the TR.ANS indication goes off.
Tip
To turn the transfer function on/off from a touch-tone phone, see page 34.
Notifying you of new message (message transfer)
The unit starts transferring the incoming message 10 seconds after the
message is recorded. To pick up the new message, you need to set
your security code (see page 33).
1 If you answer this call, you hear a transfer message for one minute, if recorded.
2
When you hear the transfer message, press (D and your security code.
3
Press the control codes ((Dl, (D2 or (1)3) to pick up the new'message (see
page 34).
Notes
• If a transfer message is not recorded, the unit does not play back a transfer message.
• If you answer the call while the incoming message is recorded,,the message is not
notified.
• If the unit cannot connect the registered phone number, it tries two more times with 15
minutes intervals. However, the unit stops trying when:
- you operate the base unit during the interval time.
- you press ( TALK) or ( FLASH/REMOTE ) of the handset during the interval time.
• If you want to cancel transferring during the message is transferred, press ( TRANSFER ).
• Don’t elapse two seconds between each digit of your security code and control code.
Tip
The memo messages and conversation recordings are not transferred.
Using as a telephone answering machine I 37™