Sony SA-VA1 - Manual (Page 15)

Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
For front full range/center woofer
speakers: with 4 ohm loads, both
channels driven, from 40 Hz -20 kHz:
rated 18 watts per channel minimum
RMS power, with no more than 0.8 %
total harmonic distortion from 250
milliwatts to rated output.
other specifications
Amplifier section
Continuous RMS power output
total 100 W
Center tweeter; 17 W (4 ohms at
10kHz,10%THD)
Front full range/center woofer :22 W +
22W
(4 ohms at 1 kHz, 10% THD)
Super woofer: 22 W (4 ohms at 40 Hz,
10% THD)
Rear 17 W (4 ohms at 1 kHz, 10%
THD)
Input sensitivity/impedance
INPUT 1 /2:450 mV, 50 kD
Output
Tone control
Front/center
Super woofer
INPUT 1/2:450 mV, lk£2
Center; 650 mV, 2 kil
Rear: Accept only supplied rear
speakers SS-SRll
R-ch: Accept only SA-VAl R-ch
speaker with supplied front L/R
speaker connecting cord
Bass; ±10 dB at 100 Hz
Treble: ±10 dB at 10 kHz
+10 dB at 30 Hz in MOVIE mode
Speaker section
Type
Front speaker system
Bassreflex type
DBR super woofer SAW type
Rear speaker Bassreflex type
Speaker unit
Front speaker system
Center tweeter: 5 cm cone type (x2)
Front full range/center woofer: 10 cm
cone type (>^)
Super woofer 13 cm cone type (x2)
Rear speaker 8 cm cone type (x2)
General
Power requirement 120 V AC, 60 Hz
Power consumption 60 W
Dimensions Approx. 180 x 1040 x 305 mm (w/h/d)
(7'/«X 41 X12 inches)
Approx. 240 X1040 x 370 mm (w/h/d,
including speaker base)
(9 '/2 X 41 X14 */s inches)
Mass Front (L): 16 kg (35 lb 3 oz)
Front (R): 13 kg (28 lb 9 oz)
Rear: 800 g/pc (1 lb 12 oz)
Supplied accessories
Front L/R speaker connecting cord,
3.5 m ( l )
Rear speaker connecting cord, 10 m (2)
Audio connecting cord, 1.5 m (1)
Remote commander RM-VAl (1)
Sony batteries SUM-3 (NS) (2)
E)esign and specihcations are subject to change without
notice.