Sony CCD-TR500 - Manual (Page 28)

Identifying the Parts
•*’IWt«lèè8
Remota
6
omnwn<ièr
Q] Transmitter
Point toward the remote sensor to control the
camcorder after turning the POWER switch on
the camcorder.
[2] Power zoom button
[3j DISPLAY button
Press to display the viewfinder screen indicators
on the TV when you connect the camcorder to a
TV.
To erase the indicators, press again.
Remote Control Direction
Lithium battery holder (p.10)
[5] START/STOPbutton
[6] HOLD switch
Slide in the direction of the arrow to prevent the
buttons from being accidentally pressed. Before
using this Remote Commander, slide In the
direction opposite to the arrow.
[ t ] Tape transport buttons
Notes on the Remote Commander
• Keep the remote sensor away from strong light sources such as direct sunlight or illumination. Otherwise, the
remote control may not be effective.
• Be sure that there is no obstacle between the remote sensor and the Remote Commander.
• This camcorder works at commander mode VTR 2. The commander modes (1,2 and 3) are used to
distinguish this camcorder from other Sony VCRs to avoid remote control misoperation. If you use another
Sony VCR at commander mode VTR 2. we recommend you change the commander mode or cover the
remote sensor of the VCR with black paper.
Warning Indicators
If indicators flash in the display window [a] or the viewfinder [b], or a caution lamp on the camcorder flahses,
check the following:
The tape is near the end.
[Ï] The tape has run out,
[4] No tape has been inserted.
[5] The tab on the tape is out (red) (p.39).
[8] Some other trouble has occurred.
Disconnect the power source and contact your
Sony dealer or local authorized facility.
[9] The lithium battery is weak or the lithium battery
is not installed (p.9).
54 55