Preparing the battery packs, Charging the battery packs, 2 charge the battery pack for about 10 hours – Sony SPP-Q200 User Manual
Page 13: Note
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Preparing the battery packs
Charging the battery packs
The two supplied battery packs must be charged before you can use
them. One should be inserted into the corcfless handset to operate it.
The other ma\' remain in the base unit to allow for a continuous
supply of fullv charged battery packs. Also, should any power
interruption occur, the base unit battery will provide backup power
during the interruption.
If a battery pack is brand new or
completely discharged, it may
take 10 minutes or more before
the CHARGE lamp lights up.
7
Insert one of the supplied battery packs
completely into the charging compartment.
The CHARGE lamp on the base unit lights.
2
Charge the battery pack for about 10 hours.
When charging is completed, the CHARGE lamp will go
off.
Note-----------------------------------------------------
Make sure that the base unit is connected to a continuous power
supply.
If the base unit's power supply is interrupted (for example, if
power is cut off every night), then the battery will provide backup
power, and will be discharged. Frequent charging and
discharging will shorten the battery's life.
If the base unit is not connected to a continuous power supply,
the battery charged in the base unit will be effective for a shorter
period of time than a fully charged battery pack when installed in
the cordless handset.
Setting up
13