Sony KV-27S10 - Manual (Page 23)

Operating a cable
box
Use CABLE POWER and the TV control
buttons (0 - 9, ENTER, JUMP and CH +/-) to
operate the cable box.
CABΠPOWER
© © ®
© ® d)r.
© © ®
0
CD
■
KV-27V10I29V11O29V10M only
Follow these instructions to set the manufacturer's code
which will enable you to operate a connected cable box
with the pre-programmed remote commander. For
example, you can set the remote commander to operate
a connected Zenith cable box.
JUMP ■
CODE SET ■
CD CD CD
CD CD
o o o
o o o
o o o
o
CS-
CD
u
-S3 C3®-
CABLE POWER
' 0-9 buttons
1
Set the CABLE BOX/TV selector to CABLE
BOX.
CABLE BOX. .TV
While pressing CODE SET, press 6 and 8
(Zenith's code number - see chart on the
right column) and ENTER.
CODE SET
+
JUMP
To operate the TV
Set the CABLE BOX/TV selector to TV. Then use the
TV control buttons to control the TV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
Manufactures and code numbers (cable box)
ManufjKturer Code number
ENTER JERROLD 60,61,62,63,64,65
PIONEER 69,70
CH
SCIENTinC ATLANTA 66,67
CABLE BOX/TV
TOCOM 71,72
selector
ZENITH 68
Notes
• If more than one code number is listed, try entering them one
by one imtil you come to the correct code for your equipment.
• If you enter a new code number, the code numbter you
previously entered at that setting is erased.
• In some cases, your cable box may use a code that is not
provided with this remote commander and you may not be
able to operate your cable box with the supplied remote
commander. In this case, use the equipment's own remote
control unit.
• When you remove a battery' from the remote commander, the
code may be erased. Reset the code each time you replace the
battery, if necessary.
Operations 23