Before contacting a service center, Before contacting, Service center – Samsung AQ 1O0 User Manual
Page 91
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before contacting
a
service center
Please check the following
The camera doesn’t switch on.
»There is low battery capacity.
—>• Insert a fresh battery. (p.15)
—¥
Charge the battery.
»Battery is inserted incorrectly with the polarities reversed.
—>• Insert the battery according to the polarity marks. (+, -)
The camera power ceases while in use.
»The battery is exhausted.
—¥
Insert a fresh battery. (p.15)
—¥
Charge the battery.
»The Camera is turned off automatically.
—¥
Turn on the camera power again.
»The camera has stopped working in a cold environment.
—>• Take the battery out of the camera and warm both by placing
them in your pocket, etc. and then immediately before
shooting, place the battery in the camera and then shoot.
Camera does not take images when you press the Shutter button.
»There is insufficient memory capacity.
—> Delete unnecessary image files.
»The memory card has not been formatted.
—> Format the memory card, (p.58)
»The memory card is exhausted.
—> Insert a new memory card.
»The memory card is locked.
—> Refer to the [Card Locked] error message.
»The camera's power is off.
—> Turn the camera power on.
»The battery is exhausted.
—> Insert a charged battery or recharge the battery, (p.15)
»The battery is inserted incorrectly with the polarities reversed.
—> Insert the battery according to the polarity marks. (+, -)
The camera suddenly stops working while in use.
»The camera stopped due to a malfunction.
—> Remove /re-insert battery and switch the camera on.
Water got inside the camera.
»The battery chamber cover was accidentally opened under water.
»The camera was dropped into water while its battery chamber
cover was not completely closed.
^ Turn the camera power off. Contact a Samsung service center
for repair.
The images are unclear.
»A picture was taken of the subject without setting an appropriate
macro mode.
—> Select an appropriate macro mode to take a clear image.
»The picture was teken beyond the flash’s range.
—> Take a picture within the flash’s range.
»The lens is smudged or dirty.
—> Clean the lens.