Sony MDP-333 - Manual (Page 4)

Precautions
On safety
• Should any solid object or liquid enter the cabinet, unplug
the unit and have it checked by qualified personnel
before operating it any further.
• Unplug the unit from the wall outlet if it is not to be used
for an extended period of time.
To disconnect a cord, pull it out by the plug. Never pull
the cord itself.
• One blade of the plug is wider than the other for the
purpose of safety and will fit into the power outlet only
one way. If you are unable to insert the plug fully into the
outlet, contact your dealer.
On installation
• Avoid placing the player in a location subject to:
— high humidity
— high temperature
— excessive dust
— mechanical vibration
— direct sunlight
• Allow adequate air circulation to prevent internal heat
buildup. Do not place the unit on surfaces (rugs, blankets,
etc.) or near materials (curtains, draperies) that may block
the ventilation holes.
• The unit will be unsteady, if it is not placed on a
horizontal level surface. To avoid being unsteady, adjust
the thickness of the supplied spacer to fill the gap and
insert it under the unit.
Make spacer
______________________ proper thickness to
j fill the gap.
Spacer sheet
0.1 mm width
(Thickness can be
adjusted between
0.1 mm and 1 mm)
On moisture condensation
• Do not operate the unit right after having transported it
from a cold location to a warm location or in a room
where the temperature rises suddenly, because moisture
may condense in the operating section of the unit. Wait
for about an hour before turning the power on in the new
location or keep the rise in room temperature gradual. If
the unit is operated with moisture condensation, the unit
and the disc may be damaged. Therefore remove the
disc immediately when there is a possibility of moisture
condensation and no picture is obtained. To evaporate
the moisture rapidly, leave the player turned on without a
disc loaded.
On operation
• Remove the disc from the tray after playing it, if the unit
will not be used for any length of time. Do not transport
the set with a disc in place.
• When the disc tray is in the open position, do not press
down on it strongly, or place heavy objects on it.
On cleaning
Clean the cabinet, panel and controls with a dry soft cloth,
or a soft cloth lightly moistened with a mild detergent
solution. Do not use any type of solvent, such as alcohol
or benzine, which may damage the finish.
On repacking
Do not throw away the carton and the packing material.
They make an ideal container to transport the unit in.
If you have any question or problem concerning your unit,
please contact your nearest Sony dealer.
For the customers In the USA
For detailed safety precautions see the leaflet
“IMPORTANT SAFEGUARDS”.
Operating Voltage
Before operating the unit, be sure that the operating
voltage of your unit is identical with that of your local
power supply.
MDP-333: 120 V AC, 60 Hz,
MDP-355GX: 100, 120, 220, 240 V AC, 50/60 Hz.
For the MDP-355GX, the voltage selector is located at
the rear.
If the selector must be reset, disconnect the AC
power cord and turn the selector with a minus
screwdriver so that the arrow on the selector points to
the appropriate voltage.
How to use the AC power plug adaptor (supplied with
the MDP-3S5GX)
If the AC plug of your unit does not fit the wall outlet,
attach the supplied AC plug adaptor.
o