Sony GV-S50 - Manual (Page 13)

Using a Battery Pack for Outdoor Use
To charge a battery pack
Before using a battery pack, make sure to charge it first even if it is newly purchased. Beside the
supplied NP-S5H battery pack, optional NF-60D, NP-66H, NP-77HD, NP-77H, NP-80 and NP-80D
battery packs, as describ^ on page 11, are available.
Use the supplied AC.S10 AC power adaptor to charge a battery pack.
1
Plug in the AC power adaptor to a wall outlet.
The POWER lamp (green) on the AC-S10 lights up and the power turns on.
Install the battery pack in the AC-S10.
Align the flat side of the battery pack with the line on the AC-S10. Then push down and siide the
battery pack in the direction of the arrow. The REFRESH lamp (red) lights up first and then it goes
out. When the CHARGE lamp (orange) lights up, battery charging begins. When the battery is
charged, the CHARGE lamp goes out. Unplug the AC power adaptor and the POWER lamp goes
out. (Refer to the instructions provided for the AC-S10 as well.)
Required charging time:
NP-SSH
(supplied)
NP-60D NP-66H NP-77H/77HD NP-80f80D
70 min. 80 min. 100 min. 140 min. 155 min.
(Approx, minutes using AC^IO)
• The battery pack cannot be charged when using the AC power adaptor is used to operate the unit.
• An NP-55H, NP-60D, NP-66H, NP-77HD, NP-77H, NP-80 and NP-80D battery pack can also be
charged with the BC-S10 or BC-77 battery charger.
To attach a battery pack to this unit
Align the upper side edge of the battery with the white line printed on the video tecorder/monitor so
that the slots of the battery are positioned over the tabs of the battery mounting surface, and slide the
battery pack while pressing it.
Jfe— n \ ^