Sony GV-M20 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recording or Editing Tapes
I
4 Act/V4t0 H
m
EOTT function' ff ft fs provfdsd with ttw ctfwr VCR.
I 5 Locals ths playback start point and prsss tha pause button on the other VCR.
I 6 Slide REC in ths direction of ths arrow and prsss PAUSEN on this unit.
This unit IS now put in recorOing pause mode.
explained on page 23.
9
. For better picture and sound,
le m which me lape has been recorded
Recording^layback time
Two tape speeds (SP/L.P) can be selected on the menu screen a
The recording lime in LP mode is twice as long as mat in SP mo<
recording in SP mode is recommended. During playback, the mo
IS selected automatically.
Difference in coior systeme
There are different formats of the TV color broadcast and eiecincity system NTSC, PAL and SECAM
Video cassette tapes are made to correspond to one of these formats. Use NTSC format cassette lapes
for this unit. You will find "P6" on the package of NTSC cassettes
10 that red color is visible
To re-record on the cesMtte, slide the ts
7
Preee the p«uM button» (PAUSE N on thi» unit} on both units to reiesss ths pauses.
If you do not press PAUSE II again on this unit wihiin five minutes, the pause mode ot this ur
released automatically and this unit stops.
8
Press the pause buttons on both units to pause the units again.
9
Rapaai steps 7 and S to edit mora aceñas.
Rear side ot a cassette
10
After editirvg ia comptatad, prase the stop buttons o on this unit) on both units to stop
I playback and recording.
• Although this unit does not have an EDIT lutKlion. using this functon on a VCR connected to this unit
lor dubbing will avoid detenoraiion of me picture on me duplicated tape.
When the tape is recorded to the end
The tape slops automatically, but me unit <$ not turned off. If you are not going to continue operation, turn
oft the power by pressing POWER.
When racordir>g from the beginning of tha tap#
Advance the tape (or about 15 seconds before recording. This will prevent missing the starling point when
pfayirvg bach on another VCR.
About recorded sound
Recording level is always fixed automatically.
The VOL - and ♦ have no effect on the recorded sound level.
ft power supply is Interrupted while recording
Recording stops.
Note
II
you record, using this unit, on a tape that has been recorded with PCM sound, and then it you play ba
this tape on a VCR with PCM function, the sound may be cut off occasionally, if this happens, set the
audio monitor switch of the VCR to the standard position.