Changing the factory setting of a function button, To reset the setting to the factory setting, O o o – Sony STR-DE515 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Receiver Operations

Operating one component while using
another (Background Operation)

You can temporality operate other components while
listening to or watching a program.

Numeric buttons -

BACKGROUND-

1

2

o o o

o o o

coo

oloja

(3

s

CD

ts ca CD

S C3 [XI

CD (X CX

O

cfa

CD

Hold down BACKGROUND.

Press both the corresponding numeric button of
the component you're going to use (see the table
below) and one of the following buttons at the
same time; VISUAL POWER, TV/VIDEO, CH
PRESET+/-, ANTTV/VTR, D.SKIP, ►,

■.

II, •.

ExampleiTo start recording on a tape deck while

listening to a CD
While holding down BACKGROUND,
press 4 (or 5) and press # at the same
time.

The numeric buttons are assigned to select the

functions as follows:

Numeric button

Operates

a

CD player

2

DAT deck

3

MD deck

4

Tape deck A

s

Tape deck B

6

LD player

7

VCR (remote control mode VTR I*")

8

VCR (remote control mode VTR 2*)

9

VCR (remote control mode VTR 3*)

0

TV

>10

DBS

Enter

DVD

Sony VCRs are operated with a VTR1,2 or 3 setting.

These correspond to Beta, 8mm and VHS respectively.

Changing the factory setting of a

function button

If the factory settings of the FUNCTION buttons (page
9) don’t match your system components, you can
change them. For example, if you have two CD players
and you don't have a tape deck or an MD recorder,

you can assign the TAPE/MD button to your second

CD player.

Note that the settings of the TUNER and PHONO
buttons cannot be changed.

Numeric buttons -

CD C3 O

CD CD CD
CD CD CD

- SYSTEM

CONTROL/
FUNCTION

0

0

0

o o o

1

Holddownthe SYSTEM CONTROL / FUNCTION

button whose function you want to change
(TAPE/MD, for example).

2

Press the corresponding numeric button of the

component you want to assign to the SYSTEM
CONTROL/FUNCTION button (1 - CD player,
for example).

For the numeric buttons, see the table in
"Operating one component while using another"
on this page.
Now you can use the TAPE/MD button to control
a second CD player.

To reset the setting to the factory setting

Repeat the above procedure.

10'

fW

Advertising