Califone PowerPro PA919PS - Manual (Page 11)

19 20
Acoustic Speaker Compliment
Woofer 10” Diameter, 40 Oz. Magnet, 2” Dia. Voice Coil, 6 Ohm
Tweeter Compression Horn Driver, 12 Oz. Magnet, 1” Voice Coil, 8 Ohm
Frequency Response 45Hz to 18KHz
Amplifier 90 Watts RMS @ 5% THD (AC)
Sound Pressure Level 94 dB, 1 Watt @ 1 Meter
Power Sources 100-240 volt AC switchmode power supply and 12 volt 7 AH
maintenance-free lead acid batteries (2)
Wireless System
Receiver: One 16-channel selectable UHF diversity wireless receiver 902 ~ 928 MHz (16 channels)
Antennas is hidden internally.
Microphone Transmitters
Handheld wireless microphone or beltpack transmitters optional.
Beltpack transmitter used with choice of hands-free headset, collar or lapel microphones.
Audio Line
Line level XLR jacks (2) providing for attaching PA916-SP speakers via cable. Features volume control for remote speaker(s).
Mixer Panel
Mixer panel accepts one wired XLR microphone. Voice music switch adds emphasis in the voice range for longer range projection.
Line-In via dual RCA jacks with volume control. Line-Out via dual RCA jacks. Separate Bass and Treble tone controls. Voice priority
switch activates “ducking circuit” which overrides music programs when microphone is used. Speaker mute switch mutes the main
speaker plus all other speakers connected. Speaker out. Both switched and unswitched 1/4” phone jacks for connecting speakers.
Dimensions 26 H x 12” W x 10” D
Weight 52 lbs.
Compliance FCC, CE, C-UL
Non-powered Companion Speaker PA916-SP
The PA916-SP is connected to one of two outputs
from the PowerPro or Powered Companion
Speaker via SP-50 Cable with 1/4” phone plugs.
Connecting to the “Speaker Out” jack will divide
the power between the PowerPro PA919SD or
PA919PS and PA916-SP. Connecting to the
“Switched Out” will disconnect the internal
speakers of the PA919SD and deliver all of the
power to the PA916-SP.
NOTE:
There are five (5) LEDs on the front of the
speaker, however they are disconnected because
there is no internal amplifier or wireless
receiver in this passive system.
Telescoping Handle
1/4” Phone Jack Speaker In
Integral Wheels
1
2
3
1
2
3
Mechanical Notations
Telescoping Handle and Wheels
These are only intended for pulling the PowerPro over relatively smooth surfaces. Using the handle to lift or
carry the unit or pulling up stairs will cause damage not covered by the warranty.
Tripod Mount
A recess is incorporated on the bottom of all PowerPro Speakers for mounting to the TP-50 tripod.
PA919PS Specifications
califone_919SD_manual_rev1.indd 22-23 6/22/09 1:22 PM