Programming the remote control, To program the internet terminal's remote control, To check if the code number works – Sony INT-W150 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Information
Programming the Remote Control
The Internet Terminal's remote control is preset at the factory to
operate Sony brand TVs. If you have a TV made by another
manufacturer that you want to operate with the Internet Terminal's
remote control, use the following procedure to program the remote
control to operate your TV.
Your TV must have infrared (IR) remote contrd receiving capability in order to be
i used with the Internet Terminal's remote control.
To program the Internet Terminal's remote control.
1
Find the code number for your TV from "Programmable Codes"
on page 20. If more than one code number is listed, use the
number listed first to complete the following procedure.
2
Press the CODE SET button.
3
Enter the code number.
4
Press the ENTER button within 10 seconds.
To Check if the Code Number Works:
Use the following procedure to make sure the code works.
□
Aim the Internet Terminal's remote control at the TV and press
the TV POWER button.
If the TV responds, try the CH+ and CH- buttons. If the TV
responds, you're done. If the code doesn't work:
□
Try programming the remote control using the other codes
listed for your TV.
□
If your TV does not respond to the Internet Terminal's remote
control—even after trying all the code numbers for your TV—
call 1-888-772-7669.
19