To program video equipment, Tips, O o o – Sony KP 51HW40 User Manual
Page 69: M^you - witliifei
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Information
To program video equipment
O o “ o '
POWER
TV))
anseuLE
..
C3
CD
AMT OWY nWID9
O o o
® ® ®
(
4
) ® (
6
)
® ®
rc5T(~Trrn
■3
-2
4
■5
1
2
3
4
5
Open the panel of the remote control.
Move the slide switch to the desired component type.
Press CODE SET inside the panel.
.iywav s ....... ...
-.. ..... .. .............. ■: .......... .
m^you
- witliifei
.....................................................
...... ........ ......................... .... ..... ........ .... ... .
Close the panel and enter the three-digit manufacturer’s code number
using the 0-9 buttons.
Press ENTER.
S To check if the code number works, aim the projection TV’s remote
control at the component, open the panel, and press the green POWER
button. If it responds, the programming is completed. If not, try using
the other codes listed for that manufacturer.
O
s
S’
§
Tips
□
□
□
if more than one code number is listed, try entering them one by one
until you come to the correct code for your component.
if you enter a new code number, the code number you previously
entered at that setting is erased.
in some rare cases, you may not be able to operate your component with
the Sony remote control, in this case, use the component’s own remote
control unit.
69