Manual tuning, To search for a station quickly (auto search), When an fm stereo broadcast contains noise – Sony AIWA NSX-V50 User Manual
Page 20: To change the am tuning interval
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RADIO RECEPTION
MANUAL TUNING
•----- MONO
TUNER
1
T
O
MONO TUNER
!)
C h/l
/ t I
A K
{
5 ;
1 Press the TUNER/BAND button to select the band
repeatedly.
FM —^ AM
r
j
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
2 Press the DOWN or ►M UP button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, is displayed.
To search for a station quickly (Auto Search)
Keep the 1« DOWN or UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the DOWN or
UP button.
• The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button to display “MONO” on the
display. -► Q
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button so that MONO
disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations (see
page 22) are cleared. The preset stations have to be set again.
20