Basic recording, Inserting blank spaces – Sony AIWA NSX-V50 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECORDING
BASIC RECORDING
1
REV MODE
(DECK 2:
Z ZD CZD
[I 0 [I s
! ¡ ~ i p Erl-'
DOLBY NR
□□NR
j
c i; il [I
T P P E E E : . : . .
BAND
TUNF.R
I
VIDEO AUX
C D
j
REO/
REG MUTE
i
J
'"i"
S U O I ] . -
CIS
I I I
I . : . . . .
This section expiains how to record from the tuner, CDs, or
external equipment. On recording from tapes, see pages 38 to
40.
Preparation
• Wind up the tape to the point where recording wiii start.
• Use normal (type I) and Cr02 (type II) tapes for recording.
1 Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded first facing
the foreground and the exposed side down.
2 Press the REV MODE button to select the reverse
mode.
To record on one side only, turn on Z.
To record on both sides, turn on ZD or CZD.
3 Press the DOLBY NR button to turn Dolby NR on
or off.
To record with DOLBY NR, turn on □□ NR.
To record without DOLBY NR, turn off □□ NR.
4 Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press the CD button and load the
disc(s).
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from the connected source, press the VÌDEO/
AUX button and play.
5 Press the • REC/REC MUTE button to start
recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press the ■ button.
To pause recording, press the II button. (Applicable when the
source is TUNER, ViDEO/AUX.) To resume recording, press
again.
To start recording with the remote control
First press the */0 REC/REC MUTE button, and then press the
button within 2 seconds.
INSERTING BLANK SPACES
insertion of 4-second biank spaces enables activation of the,
Music Sensor function. (Appiicable when the source is TUNER
or VIDEO/AUX.)
1 Press the • REC/REC MUTE button during recording or
whiie in recording pause mode.
on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press the II button to resume recording.
To insert a biank space of iess than 4 seconds, press the •
REC/REC MUTE button again while KT3il is fiashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press the • REC/REC MUTE
button again. Each time the button is pressed, a 4-second biank
space is added.
36