Sony KP- 57WV600 - Manual (Page 52)

Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
Sony Equipment
Beta, Ed Beta VCRs
8 iriin VCR
VHS VCR ..............
DVD player
Switch Position on
Remote Control
AVI
AV2
AV3
DVD
Programmable Code
Number
303
302
301
751
If you have video equipment other than Sony brand that you want to
control with the TV's remote control, use the following procedure to
program the remote control.
‘ ^ The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
1 Turn to the list of "Manufacturer's Codes" on page 52, and find
the three-digit code number for the manufacturer of your
equipment. (If more than one code number is listed, use the
number listed first.)
2 Open the remote control and set the A/V slide switch to 1, 2, 3, or
DVD.
3 Press
CODE SET.
4 Enter the three-digit manufacturer's code number.
5 Press
ENTER.
^ You must do step 5 within 10 seconds of step 4,
steps 3 through S.
or you must redo
6 To check if the code number works, aim the TV's remote control
at the equipment and press the POWER button that corresponds
with that equipment. If it responds, you are done. If not, try using
another code listed for that manufacturer.
Notes
_l If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
□ If you enter a new code number, the code number you previously
entered at that setting is erased.
□ In some cases, you may not be able to operate your equipment
with the supplied remote control. In such cases, use the
equipment's own remote control unit.
■J Whenever you remove the batteries to replace them, the code
numbers may revert to the factory setting and must be reset.
51