Compatible Systems DS3-10/100 - Manual (Page 10)

Chapter 2 - Quickstart Configuration 6
Suggested for AppleTalk
You may want to set your own network numbers, rather than using the autoconfigured values.
You may also want to use more meaningful zone names.
CV: Use the AppleTalk Routing: Ethernet Dialog Box.
TB: Use configure and set keywords in the AppleTalk Phase 2 Ethernet 0 section.
DECnet Protocol
Required for DECnet
The router’s shipping configuration does not have DECnet turned on. In order to be used,
DECnet must be turned on both globally and for a particular port.
• Set DECnet on (globally, and for this port)
• Set DECnet area
• Set DECnet node
CV: Use the DECnet Routing Dialog Box (under Global/DECnet Routing) and the DECnet:
Ethernet Dialog Box.
TB: Use configure and set the Mode keyword in the DECnet Ethernet 0 section. Use
configure and set the Enabled, Area, and Node keywords in the DECnet Global section.
v Note: Setting DECnet on for any port with the command line also sets DECnet on globally.
In CompatiView you must set a global parameter and a port-specific parameter.
Suggested for DECnet
Setting the parameters above should be adequate for most installations.
WAN Interface Configuration
In order to use the WAN interface, you may want to set some physical parameters. Then set up
the link and protocol parameters.
Internal DS3 CSU/DSU Physical Communications Settings
Required for Dedicated Line Operation
No changes from the default values are required for standard operation over a DS3 line. The
default values are listed in Chapter 3.
Suggested for Dedicated Line Operation
Changing to a different Line Build Out may be required. These parameters can only be set
using the command line interface.
TB: Use configure and the DS3 Interface WAN 0 section.