Ppp configuration, Internal ds3 csu/dsu link configuration, Required for dedicated line operation – Compatible Systems DS3-10/100 User Manual
Page 11: Suggested for dedicated line operation, Ip protocol, Required for ip, Suggested for ip, Ipx protocol, Required for ipx, Appletalk protocol
Chapter 2 - Quickstart Configuration
7
PPP Configuration
This section covers the settings required for PPP (point-to-point) protocol operation of the DS3
WAN interface.
Internal DS3 CSU/DSU Link Configuration
Required for Dedicated Line Operation
This is the only mode of operation supported via the built-in DS3 CSU/DSU.
•
Set Dedicated connection
•
Set PPP connection
CV: Use the Link Configuration: WAN Dialog Box.
TB: Use configure and then set the Mode and ConnectMode keywords in the Link Config
WAN 0 section.
Suggested for Dedicated Line Operation
Dedicated line operation generally does not require additional parameters for operation.
IP Protocol
Required for IP
WAN interfaces which are set for PPP operation do not generally use an IP address. They are
set to act as an “unnumbered interface.” In this mode of operation, there are no required
settings.
Suggested for IP
These parameters help supply information about the segment that the interface is connected to.
With this information, routing can take place.
•
Set IP RIP 1, IP RIP 2, OSPF (Open Shortest Path First) or BGP (Border Gateway
Protocol)
•
Set IP static routes
CV: Use the TCP/IP Routing: WAN Dialog Box to set RIP, and the IP Static Routing Dialog
Box (under Global/IP Static Routes) to set static routes. OSPF and BGP can only be config-
ured using text-based configuration.
TB: Use configure and set either the RIPVersion keyword or the OSPFEnabled keyword in
the IP WAN 0 section. Add static routes and a default router in the IP Static section.
v Note: Due to the complexity of BGP, configuration parameters for BGP are not given in this
Quickstart. For help with BGP configuration parameters, and other configuration questions,
refer to the Tech Support pages on the Compatible Systems Web site at:
http://www.compatible.com/.
IPX Protocol
Required for IPX
WAN interfaces which are set for PPP operation do not generally use an IPX address. They are
set to act as an “unnumbered interface.” In this mode of operation, there are no required
settings.
AppleTalk Protocol
Required for AppleTalk
WAN interfaces which are set for PPP operation do not generally use an AppleTalk address.
They are set to act as an “unnumbered interface.” In this mode of operation, there are no
required settings.