Sony ICF-CD833 - Manual (Page 11)

Setting the Sleep
Timer
By setting the sleep timer, you can fall asleep to
the radio sound. The radio turns off after the
selected time.
1. Turn on the radio and tune in the
desired station. See "Playing the
Radio".
2. Press RADIO/SLEEP while the band
and frequency of the station appear.
3 . Select the desired operating time by
pressing RADIO/SLEEP.
Each time you press RADIO/SLEEP, the
sleep timer indication changes as
follows.
90 -► 60 -» 30 -► 15 -♦ Off
t__ Frequency indication <J
The sleep timer is set and it will go off
after the selected minutes. After 5
seconds, the indication becomes the
current time.
• To turn off the sleep timer, press SNOOZE/
SLEEP OFF.
• To cancel the sleep timer, select OFF or press
RADIO/SLEEP again after the indication
becomes the current time at step 3.
To Use Both Sleep Timer and Alarm
You can fall asleep to the radio sound and you
will be awakened by the CD, radio or buzzer
alarm at the preset time.
1. Set the alarm. (See "Setting the Alarm".)
2. Set the sleep timer. (See "Setting the
Sleep Timer".)
Specifications
CD player section
System: Compact disc digital audio system
Laser diode properties: Material: GaAIAs
Wavelength; 780 n m
Emission duration: Continuous
Laser output: Less than 44.6 pW
(This output is the value measured at a
distance of about 2(K) mm from the objective
lens surface on the optical pick-up block with
7 mm aperture.)
Frequency response: 20-20,000 Hz .‘/^dB
Wow and flutter: Below measurable limit
Radio section
Frequency range:
FM: 87.5-108.0 MHz
AM; 530-1,710 kHz
Scan step
FM: 0.1 MHz (fixed)
AM: 10 kHz (fixed)
General
Speaker:
Full range: 9 x 5 cm (3 5/8 x 2 inches)
4a
Power outputs: 1.2 W + 1.2 W (at 10% harmonic
distortion)
Power requirements: 120 V AC, 60 Hz
Dimensions:
Approx. 176x177.6 xl93.5 mm (w/h/d)
(Approx. 7 x 7 x 7 5/;K inches) incl.
projecting parts and controls
Mass: Approx. 1.8kg (31b 15oz)
Design and specifications are subject to change
without notice.
Precautions
• Operate the unit only on 120 V AC, 60 Hz.
• The nameplate indicating voltage, etc. is
located at the bottom.
• Disconnect the cord by grasping the plug.
Never pull it by the cord.
• As the laser beam used in the CD player
section is harmful to the eyes, do not attempt
to disassemble the casing.
Refer servicing to qualified personnel only.
• Do not leave the unit in a location near a heat
source such as a radiator or airduct, or in a
place subject to direct sunlight, excessive dust,
mechanical vibration, or shock.
• Allow adequate air circulation to prevent
internal heat build-up. Do not place the unit
on a surface (a rug, a blanket, etc.) or near
materials (a curtain) which might block the
ventilation holes.
• Should any liquid or solid object fall into the
unit, unplug the unit and have it checked by a
qualified personnel before operating it further.
• When the casing becomes soiled, clean it with
a soft cloth dampened with a mild detergent
solution. Never use abrasive cleansers or
chemical solvents, as they may mar the casing.
If you have any question, please consult your
nearest Sony dealer.