Setting up – Sony GDM-2000TC User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting up
1
Set tlie monitor to the control stand.
Do not put your hands between the monitor and
control stand when setting the control stand.
Set the control stand properly so as not to damage it.
Secure the monitor with four screws on right and left sides
of the stand.
Be sure to lock all four parts for safety.
3
Put the attached cable clamp on the rear side of the
monitor, connect the signal cord and DC power cord to
the monitor through the clamp, and close up clamp.
4
Connect the AC power cord to the monitor and to a wall
outlet. (Use the shielded AC Power cord included m
your package.)
-asrfin
to a wall outlet
5
Connect the RGB sensor to the PROBE connector.