Sony KW-34HD1 - Manual (Page 55)

other Information
Programming the
Remote Control
Programmable
Code Number
The remote control is preset to operate Sony brand video equipment.
Switch Position on
Remote Control
VTRl 303
VTR2 302
^WR3 ...................................... 301
Sony
Equipment
Beta, ED Beta VCRs
8 mm VCR
VHSWR
DVD Player DVD/MDP 751
If you have video equipment other than Sony brand that you want to control
with the DTV's remote control, use the following procedures to program the
remote control.
^ The equipment must have infrared (IR) remote capability in order to be used with the remote control.
1 Turn to "Programmable Codes" on page 58, and find the three-digit code
number for your equipment. If more than one code number is listed, use
the number listed first to complete the following procedures.
You must perform step 3 within 10 seconds of step 2, or you must start again from step 2.
2 Press CODE SET.
3 Enter the three-digit code number.
4 Press ENTER.
To Check if the Code Number Works
Use the following procedure to make sure the code you've entered works:
1 Aim the DTV's remote control at the equipment and press the POWER
button that corresponds to that equipment.
2 If the equipment responds, you're done. If the code doesn't work for your
equipment:
□ Try programming the remote control using the other codes listed for
your equipment.
□ If you cannot get your equipment to respond to the DTV's remote
control — even after trying all the code numbers for your equipment
— your equipment may not be compatible with the DTV's remote
control. If this happens, you must use your equipment's own remote
control to operate it. Try using the Learn feature to program specific
buttons. See "Using the Learn Function" on page 61.
Tips
□
□
If more than one code number is listed, try entering them one by one until
you come to the correct code for your equipment.
If you enter a new code number, the code number you previously entered
at that setting is erased.
□ In some rare cases, you may not be able to operate your equipment with
the supplied remote control. In this case, use the equipment's own remote
control unit.
□ Whenever you remove the batteries to replace them, for example if too
much time is taken, the code numbers may revert to the factory setting
and must be reset.