Troubleshooting, Specifications, Additional information – Sony CDP-CX88ES User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional Information
Troubleshooting
It vou experience anv ot the following difficulties while
using the player, use this troubleshooting guide to help
vou remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There Is no sound.
^Check that the player is connected securely.
■ ^Make sure you operate the amplifier correctly.
The CD does not play.
^There is no CD in a slot ("-NO DISC-"
appears).
Insert a CD.
■ ^Insert the CD with the label side facing right.
^Clean the CD (see page 32).
^Moisture has condensed inside the player. Open
the front cover and leave the player turned on
for about an hour (see page 32).
The remote does not function.
"► Remove obstacles in the path of the remote and
the player.
^Point the remote at the remote sensor @ on the
player.
^Be sure to connect the player and the
transmitter/receiver correctly.
^Be sure to set up the remote correctly.
^Turn both the player and the transmitter/
receiver on.
^Point the remote at the remote sensor @ on the
player and the transmitter/receiver.
■ ► •Replace all the batteries in the c^mote vvith new
ones if <X3 appears in the remote's display.
The player functions incorrectly.
■ ► ^The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
. connect it back to the wall outlet to reset the
player.
Specifications
Compact disc player
Laser
Semiconductor laser { X = 780 nm)
Emission duration: continuous
Laser output
Max 44.6 pVV*
* This output IS the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
20 Hz to 20 kHz ±0.5 dB
Signal-to-noise ratio
More than 110 dB
Dynamic range
More than 98 dB
Harmonic distortion
Less than 0.0030 'k,
Channel separation
More than 100 dB
Outputs
Jack
type
Maximum Load impedance
output
level
LINE our
Phono
jacks
2 V Over 10 kilohms
(at 50 kilohms)
DIGITAL OUT
Optical
(OPTICAL)
output
connector
-18 dBm Wavelength; 660 nm
General
Power requirements
120 V AC, 60 Hz
Power consumption
15 W
Dimensions (approx.)
(w/h/d)
When the front cover is dosed
430 X 200 X 480 mm (17 x 7 7/8 x 19 in.)
inch projecting parts
Mass (approx.)
9.5 kg (20 lbs 15 oz)
Supplied accessories
• Audio cord (1)
• CD booklet holders (2) and label (1 )
• AC adapter (1)
• Monaural (2P) mini-plug cord (1)
• Remote commander (remote) (1)
• Sony LR6 batteries (3)
• Transmitter/receiver (1)
Design and specifications are subject to change without notice.
3 3 ^