Sony CDP-CX88ES - Manual (Page 5)

Getting Started
Hooking Up the System
Overview
This section describes how to hook up the CD plaver to
an amplifier. Be sure to turn off the power of each
component before making the connections.
Transm itter/recei ver
To an AC outlet
What cords will I need?
Audio cord (1) (supplied)
Hookups
When connecting the audio cord, be sure to match the
color-coded cords to the appropriate jacks on the
components; Red (right) to Red and White (left) to
White. Be sure to make connections firmly to a\ oid
hum and noise.
Amplifier
To connect the transmitter/receiver
Connect the transmitter/receiver to an AC outlet using a
AC adapter (supplied) and via the S-LINK CONTROL A1
jack using a monaural mini-plug cord (supplied).
T ransmitter/receiver
DC IN 6V
To an AC outlet
CD player Transmitter/receiver
CONTROLAI
AC adapter (1 ) (supplied)
Note
• Use the supplied AC adapter. Do not use any other AC
adapter since it may cause the CD player to malfunction.
When replacing the AC adapter, use the same type
number AC-IAIO.
• If you have a Sony receiver (amplifier) equipped with
the CONTROLAI jack
Be sure to connect the player to the CD IN jacks on the
receiver (amplifier). When making this connection, set the
COMMAND MODE of the player to CD! (see the
illustration on the next page). If you further connect the
player and the receiver (amplifier) via the CONTROL A1
jacks with the monaural (2P) mini-plug cord, you can use
the Auto Function feature between these components. For
details, refer to the supplementary "S-LINK^^/CONTROL-
A1 Control System" instructions and the instructions
supplied with the receiver (amplifier).