Preparing and using the remote control, Quick tips – CyberHome Entertainment Cyber Home CHLDV712 User Manual

Page 9

Advertising
background image

8

Quick Tips

Ÿ Make sure no objects

are between the remote
and the player.

Ÿ Similar remote controls

could interfere with the
function of the player.

Ÿ Make sure not to store

the remote upside
down or with any
objects pressing on the
buttons - this could
drain the battery.

30

30

Operation of Remote Control

When using the Remote control, please aim at the device's remote control sensor, located on the
front of DVD Player. A 30 degree angle is recommended for best operation.

Installing the Battery

If the remote control only operates when you get closer to the DVD Player, it may indicate that the battery is
weak. Please replace the battery (Lithium battery) simultaneously with a new battery of the same type (CR 2025).
Please note the positive (+) side is facing upwards when the remote is held as shown below.

Important Notes about the Battery

Ÿ If the unit will not be used for an extended length of time, it’s wise to remove the battery before storage.

Ÿ The life of the battery depends on the amount of usage. With typical usage, a battery life of approximately 6

months can be expected.

1. Pull out the Battery Holder to remove
the battery compartment.

2. Insert new Battery into the
Battery Holder. Make sure that
Positive (+) side is facing upwards.

3. Return the Battery Holder
back into the remote.

Preparing and Using the Remote Control

Remote Control

Bottom

Remote Control

Bottom

Advertising