Sony ICF-C113VSILVE - Manual (Page 6)

1 Plug in the clock radio.
"AM 12.O0" will flash in the display.
2 Press Q.OOC for a few seconds.
You will hear a beep and the year will start to
flash in the display.
3 Press TUNCrriME SET + or - until the
correct year appears in Úre display.
4 Press aOCK once.
5 Repeat steps 3 and 4 to set the rnonth,
date, hour, and minute.
After setting the minute, press and release
CLOCK to start the counting of the seconds.
• To display the year and date, press SNOOZE/
DATE/SLEEP OFF orvce for the date and within
2 seconds press it again for the year. The date
or year will appear in the display for a few
seconds and the display returns to the
current time.
When
SNOOZE/DATE/SLEEP OFF is pressed
while the SNOOZE function is operating, the
year and date will not appear in the display.
• To set the current time rapidly, hold down the
+ or-button.
• To set the cunwt time from zero seconds,
release CLOCK with the time signal at step 5.
To change the display to the
daylight saving time (summer time)
indication
Pnxs D.S.TysUMMER T.
" ^ " is displayed and the time indication
changes to summer time.
To cancel the summer time indication, press
D.S.T./SUMMERT. again.
Playing the Radio
Manual Tuning
1 Press RADIO ON to turn on Üte radio.
The band and frequency will appear in the
display for a few seconds and dte
current time indication returns to the display.
2 Press BAND repeatedly to select the
desired band.
3 Use TUNE/TIME SET + or - to tune in
the desired station.
The FM frequency advances or reverses in 0.1
MHz channel steps and the AM frequerxcy in
10 kHz chatmei steps.
A beep sounds when d)e upper or lower
extremity of the band range is reached.
4 Adjust volume usii^ VOLUME.
• To turn off the radio, press RADIO OFF.
• To improve reception
TV/WEATHER/FM; Extend the FM wire
antenna fully to increase FM re<»ption
sensitivity.
AM: Rotate the unit horizontally for optimum
reception. A ferrite bar antenna is built in
totfwunit.
• To check the current station, press the + or -
button lightly. The band and frequency are ^
displayed for a few seconds, after which the
current time indication returns to the display.
• if the radio alarm A RADIO comes on while
the radio is playing, the station switches to the
frequency set under preset number
1 .
To listen to the WEATHER band
1 Press RADIO ON to turn on dte radio.
2 Press WEATHER to switch to the
WEATHER band.
"WEATHER* will appear in the display.
3 Press TUNEHIME SET + or-
repeatedly until tfve desired channel
appears in the display.
To switch back to the previous band, press
BAND.
To set the brightness of the
backlight
Set BRIGHTNESS to H (high) or L (low) to make
the display more visible.