Operating a cable converter box, Notes, Code set – Sony KV-27TS29 User Manual
Page 57: Cable power, Jump, To operate the tv, For more details on operating the cable box
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Manufacluter ' '' ?
JERROLD
60,61,62, 63,64,65
PIONEER
69,70
SCIENTIFIC ATLANTA
66, 67
TOCOM
71,72
ZENITH
68
Operating a Cable Converter Box
Follow these instructions to set the manufacturer's code which will enable you to
operate a connected cable converter box with the pre-programmed Remote
Commander.
EXAMPLE: Operate a connected Zenith cable converter box.
1
Set the CABLEBOX-TV selector to CABLEBOX.
CABLEBOX TV
Notes
• If more than one code number is listed, try entering them one by one until you come to
the correct code for your equipment.
• If you enter a new code number, the code number you previously entered at that setting is
erased.
• In some rare cases, your equipment may use a code that is not provided with this
Remote Commander and you may not be able to operate your cable converter box with
the supplied Remote Commander. In this case, use the equipment's own remote control
unit.
2
While pressing CODE SET, press 6 and 8 (Zenith's code number -see
chart below) and ENTER.
CODE SET
+
Use CABLE POWER and the TV control buttons (0 - 9, ENTER, JUMP and
CH
+!-)
to operate the cable converter box.
CABLE POWER
©
0
©
® © ©
0
© ©
© S
JUMP
Manufactures and Code Numbers (cable box)
To operate the TV
Set the CABLEBOX-TV selector to TV, then use the TV control buttons to control
the TV.
For more details on operating the cable box
Refer to the operating instructions that come with the cable box.
“O
»
■D
33
CD
3
3
3
Chapters: Using Advanced Features
57