After one second, Programmed tracks, Total playing time – Sony CDP-CA80ES User Manual
Page 16: To make a correction, To cancel program play, Note, Creating a program using the remote [t), Track number, Playing cds
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Playing CDs
3
Press the number buttons of the tracks you want to
program in the order you want.
To program, the track numbered over 10, use the
>10 button.
Last programmed playing order
After one second
Programmed tracks
PROGRAM
2 3 4 5
5
DISC TRACK MIN SEC
i
1 5 , 1 3 . 1 S , c . :
Total playing time
To make a correction
Press CLEAR, then repeat this step.
4
To program other discs or tracks, do the following:
To program
Repeat Step(s)
All tracks on other discs
2
Other tracks on the same disc
3
Other tracks on other discs
2 and 3
5
Press ► (the indicator lights up green) to start
Program Play.
To cancel Program Play
Press CONTINUE.
'Q' You can create your program while checking the disc
labels
While the disc tray is open, follow Steps 1 to 5 while
pressing the DISC SKIP button after each step to check
the disc labels. If you close the disc tray before Step 5, the
total playing time appears in the display after a while.
Note that, if the programmed track number isn't found
on the disc, that step is automatically erased.
'Q' The program remains even after the Program Play
ends
When you press the ► button, you can play the same
program again.
The program remains until you erase it or turn off the
player
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that aren't found in the player or on the disc are
deleted from the program, and the rest of the program is
played in the programmed order.
Note
The total playing time doesn't appear when:
—You have programmed a track whose number exceeds 20.
—The total playing time of the program exceeds 200 minutes.
Creating a program using the remote [T)
1
Press PROGRAM.
"PROGRAM" appears in the display.
2
Press DISC.
XJRAM
D I S C - L i J
3
Press the number button of the disc.
¡ f ) 2
3
4
5
\ * /
r i i s c - E i : - ]
4
Press ENTER to select the disc.
2
3
4
5
TRACK
MIN
SEC
:i. ¿Sc
f^i
1 A L 4 = ^
when you want to program the whole disc as one
step, skip Steps 5 to 6, and go to Step 7.
5
Press
until the track number you want
appears in the display.
Track number
Total playing time being programmed
PROGRAM
2 3
DISC ^ TRACK MIN
4 5
s e c -
i
1 5 1 3 . 1 8 » , :
14